Manual Description
If gauge indicates more than the level shown in figure (full or almost full), drain fuel from fuel tank J until gauge indicates level shown in figure or below. Insert fuel tube into fuel tank through fuel filler hose to draw fuel from fuel tank. Remove the inspection hole cover for main and sub fuel level sensor unit by turning clips counterclockwise by 90°.
Do not remove the remaining retainer on the hard tube (or the equivalent) except when the resin tube or the retainer is replaced. When the resin tube or hard tube (or the equivalent) is replaced, also replace the retainer with a new one. Remove main fuel level sensor unit, fuel filter and fuel pump H assembly, and sub fuel level sensor unit.
L Connect fuel hose connector (push in until it stops) and sub fuel level sensor unit harness connector. Align the connector with the tube, then insert the connector straight into the tube until a click is heard. Start the engine and let it idle and make sure there are no fuel leaks at the fuel system connections.
Manual Cover
General