Manual Description
Put alignment marks on disc rotor and wheel hub and bearing assembly, then remove disc rotor. Using a puller (suitable tool), remove wheel hub and bearing assembly from drive shaft. Do not allow drive shaft to hang down without support for counter shaft, wheel joints, and other parts.
Remove fixing bolts of wheel hub and bearing assembly, then remove wheel hub and bearing assembly from axle. Remove shock absorber fixing bolt (lower), front lower link fixing bolt and nut (axle-side) while supporting rear lower link with jack. Remove fixing nuts of anchor block, then remove anchor block and back plate from axle.
Remove wheel hub and bearing assembly fixing bolts, then remove wheel hub and bearing assembly from axle. Put matching marks on slide joint assembly and shaft before separating slide joint assembly. While rotating ball cage, remove old grease on joint sub-assembly with paper towels.
Manual Cover
General