Manual Description
Push drive shaft, then press-fit circular clip on the drive shaft into circular clip groove of side gear. Put matching marks on slide joint assembly and shaft before separating joint assembly. Remove stopper ring with a flat-bladed screwdriver, and pull out slide joint housing.
While rotating ball cage, remove old grease on joint sub-assembly with paper towels. Install spider assembly securely, making sure the matching E marks which were made during disassembly are properly aligned. After installed, pull shaft to check engagement between joint sub-assembly and stopper ring.
After installing housing and shaft, rotate boot to check whether or not the actual position is correct. After inserting grease, use a shop cloth to wipe off old grease that has oozed out. Put matching marks on slide joint assembly and shaft before separating slide joint assembly.
Manual Cover
General