Manual Description
Prevention of the entry of foreign objects must be taken into account during disassembly of the service location. Disassembled parts must be carefully reassembled in the correct order. If work is interrupted, a clean cover must be placed over parts.
Disassembled parts (except for rubber parts) should be cleaned with kerosene which shall be removed by blowing with air or wiping with paper shop cloths. If there are any irregular conditions, replace wheel hub and bearing assembly. Hang it in a place where it will not interfere with work.
Put alignment marks on disc rotor and wheel hub and bearing assembly, then remove disc rotor. Remove parking cable and parking brake shoe from back plate. Using a puller (suitable tool), remove wheel hub and bearing assembly from drive shaft.
Manual Cover
General