Manual Description
Each control unit transmits/receives data but selectively reads required data only. B Turn wiper dial position to 4 except when checking waveform or voltage of wiper dial position. Remove wiper motor and linkage mounting bolts, and remove wiper motor and linkage.
If necessary, ensure that washer fluid spray covers at least the area as shown in the figure. If they are installed correctly, and the fluid is still spraying out of the shooting target areas, replace them C with new washer nozzle and/or cowl top cover. If attempts are made to adjust the washer nozzle with needle pin, damage may occur.
Push the Washer nozzle in direction by the arrow as shown in the figure and remove it. Remove instrument driver lower panel, steering column lower cover and combination meter. Pull wiper and washer switch toward the passenger door while pressing pawls in direction shown by the arrow in the figure, and C remove it from the base.
Manual Cover
General