Manual Description
A sulfated battery may sometimes be brought back into service by means of a long, slow charge, 12 hours or more, followed by G a battery capacity test. Use the following chart to correct your hydrometer reading according to electrolyte temperature. If battery surface charge is detected while testing, the tester will prompt you to turn on the headlights to remove the surface charge.
If this occurs, clean the battery post and terminals, reconnect them and restart the test. Locate the battery type and rating stamped or written on the top case of the battery to be tested. The starter motor plunger closes and provides a closed circuit between the battery and the starter motor.
Check voltage between starter motor connector F27 terminal 2 and ground using a digital circuit tester. Check voltage between starter motor connector E207 terminal 1 and ground using a digital circuit tester. Check voltage between starter motor connector E207 terminal 1 and battery positive terminal using a digital circuit tester.
Manual Cover
General