Manual Description
Check continuity between the front combination lamp harness connectors and ground. Check continuity between the rear combination lamp harnness connectors and ground. Adjust beam pattern until cut-off line (top edge of illumination area) is positioned at the specified height off ground.
Adjust front fog lamps using adjustment screw so that the top J edge of the high intensity zone is 100 mm (4 in) below the height of the fog lamp centers as shown. Disconnect the front combination lamp connector and remove front combination lamp. Twist the optical sensor (1) counter clockwise to remove it from the defroster grille.
Touching the I glass could significantly affect the bulb life and/or fog lamp performance. While pressing tabs, pull lighting and turn signal switch toward driver door and release from the steering column.
Manual Cover
General