Manual Description
Position a suitable jack under the front lower link to support the shock absorber. Position the drilled hole downward and drain oil by moving the piston rod several times. Remove the shock absorber upper and lower end bolts using power tool, and remove the shock absorber.
Remove the suspension arm upper nuts and bolts on the suspension member side using power tool. Remove the suspension arm pinch bolt and nut on the knuckle side using power tool. C Before checking, turn the ball joint at least 10 revolutions so that the ball joint is properly broken in.
Remove the adjusting bolt and nut, and the bolt and nut, from the front lower link and rear suspension member using power tool. Remove the front lower link pinch bolt and nut on the knuckle side using power tool. Replace suspension arm assembly if any of the following exists: - Ball stud is worn.
Manual Cover
General