Manual Description
Using a piece of wood and a hammer, tap on the wheel hub lock nut to disengage the drive shaft from the wheel hub and bearing. Using a piece of wood and a hammer, tap on the wheel hub lock nut to disengage drive shaft from wheel hub and bearing. Put matching marks on slide joint housing and shaft before separating joint assembly.
K If joint sub-assembly cannot be removed after five or more unsuccessful attempts, replace the entire drive shaft assembly. Install spider assembly securely, making sure the matching marks which were made during disassembly are properly aligned. After installation, pull shaft to check engagement between slide joint assembly and stopper ring.
If boot position is not correct, remove old boot bands then reposition the boot and secure with new boot bands. After inserting K grease, use a shop cloth to wipe off old grease that has oozed out. After installing housing and shaft, rotate boot to check whether or not the actual position is correct.
Manual Cover
General