Manual Description
If the combination switch (lighting and turn signal switch) position is changed, then the illumination lamps are turned off after a 30 second delay. Check that any concerns occur other than those mentioned in the customer E interview. While operating the test item, check voltage between push-button ignition switch connector M17 terminal 5 and ground.
Check continuity between push-button ignition switch harness connector M17 terminal 6 and ground. Remove the two bracket screws, then remove the front room/map lamp assembly bracket from front room/map assembly and position aside. Release the back plate pawls using a suitable tool and remove the front room/map lamp assembly.
Insert a suitable tool into the gap between the lens and vanity lamp, then gently release the lens pawls and remove. Insert bulb socket into glove box assembly and rotate clockwise to lock in position. Insert bulb socket into foot lamp housing and rotate clockwise to lock in position.
Manual Cover
General