Manual Description
The gasket for intake manifold collector (upper) is secured together with intake manifold collector (lower) bolt. Thus, when replacing only the upper gasket the lower gasket must also be replaced. Remove upper air cleaner case, mass air flow sensor, and air cleaner to electric throttle control actuator tube as an assembly.
Disconnect the power steering hose bracket from the back of the intake manifold collector (upper). If necessary, remove the intake manifold collector (upper) bolts in the order as shown, using power tool and remove the intake manifold collector (upper). If necessary, remove power valve bolts in the order as shown H and remove the power valve.
Loosen the intake manifold nuts and bolts in the order as shown J using power tool, and remove the intake manifold. When removing the front and rear engine mounting through bolts and nuts, lift the engine up slightly for safety. Remove harness connector of each sensor, and disconnect the harness from the bracket and middle clamp.
Manual Cover
General