Manual Description
Remove the air cleaner to electric throttle control actuator tube attached to air cleaner case (upper). Disconnect the master cylinder brake tubes and the hose from the reservoir tank to the sub tank using a suitable tool. Place master cylinder onto brake booster and tighten the master cylinder nuts to specification.
Connect the sub tank hose to the master cylinder reservoir tank and fill the sub tank with new brake fluid. Plug all ports on master cylinder with your fingers to prevent air suction while releasing brake pedal. Have an assistant depress brake pedal slowly several times until no air comes out of the master cylinder.
The piston inside the master cylinder might pop out when this is done, so hold the stopper cap down at the same time. Place the side flange of cylinder body with chamfering around the pin insertion hole facing up, and firmly set master cylinder assembly in a vise. Carefully pull the primary piston assembly straight out to prevent cylinder inner wall from being damaged using a suitable tool.
Manual Cover
General