Manual Description
Remove air cleaner case (upper), mass air flow sensor, and air cleaner to electric throttle control actuator tube as an assembly. Loosen the intake manifold nuts and bolts in the order as shown using power tool, and remove the intake manifold. Remove harness connector of each sensor, and disconnect the harness from the bracket and middle clamp.
Remove exhaust manifold and three way catalyst manifold heat shields using power tool. If re-installing the original oil pan, remove the old sealant from the mating surfaces using a scraper. Apply a bead of sealant to the cylinder block mating surface of the upper oil pan as shown.
Disconnect the mass air flow sensor electrical connector and remove the air cleaner case (upper), mass air flow sensor and L air cleaner to electric throttle control actuator tube. Disconnect the mass air flow sensor electrical connector and remove the air cleaner case (upper), mass air flow sensor and air cleaner to electric throttle control actuator tube. Make sure no foreign substances are deposited in and around the fuel tube and quick connector and that there is no damage.
Manual Cover
General