Manual Description
Put alignment marks on disc rotor and wheel hub and bearing assembly, then remove disc rotor. Remove steering outer tie-rod cotter pin at steering knuckle, then loosen nut using power tool. Remove wheel hub and bearing assembly from drive shaft using a puller or suitable tool.
Remove the lower ball joint pinch bolt using power tool, then separate lower ball joint from steering knuckle. Remove drive shaft from wheel hub and bearing assembly, using a puller or suitable tool. Remove drive shaft from transaxle using Tool and drive shaft puller or suitable tool.
I If it pulls out, the circlip is not properly meshed with the transaxle side gear. Remove support bearing bolts using power tool, and pry drive shaft from transaxle. Put matching marks on slide joint housing and shaft before separating joint assembly.
Manual Cover
General