Manual Description
If the seat belt does not return smoothly, wipe the inside of the loops with a clean paper cloth. Dirt build-up in the A loops of the upper anchors can cause the seat belts to retract slowly. If the webbing does not return smoothly, the cause may be an accumulation of dust or dirt.
Fix the seat belt at the center pillar webbing opening with a clip or other device. Hold both ends of the wire and pull it tightly while moving it up and down several times along the webbing opening surface to remove dirt D stuck there. Any dirt that cannot be removed with the wire can be removed by cleaning the opening with a clean cloth.
Apply tape at the point where the webbing contacts the through-anchor webbing opening. Allow the entire length of the webbing to retract to cancel the automatic locking mode. Never perform the following test on wet or gravel roads or on public streets and highways.
Manual Cover
General