Manual Description
Install inspection hole covers with the front mark (arrow) facing front of vehicle. Then let it idle and check that there is no fuel leakage at the fuel system connections. F When resin tube or hard tube (or the equivalent) is replaced, also replace retainer with new one.
Raise fuel level sensor unit, fuel filter and fuel pump assembly O (1), and disconnect fuel tube and harness connector. Using the rope left on the fuel tank side at removal, run the fuel tube inside the fuel tank to install the sub fuel level sensor assembly to the fuel tank. Align the connector with the tube, then insert the connector straight into the tube until a click” sound is heard.
Remove parking brake cable mounting bolts and separate parking brake cable from suspension arm. Align the matching side connection part with the center of shaft, and insert connector straight until it clicks. Remove final drive mounting bolts (B) from final drive mounting bracket (3) to tilt final drive assembly (2).
Manual Cover
General