Manual Description
The basic ignition timing is programmed within the anti-knocking zone, if recommended fuel is used under dry conditions. Fuel cut will operate until the engine speed reaches 2,000 rpm, then fuel cut is cancelled. Each control unit transmits/receives data but selectively reads required data only.
Check service records for any recent repairs that may indicate a related malfunction, or a current need for scheduled maintenance. Start engine and warm it up until engine coolant temperature indicator points the middle of gauge. Rev engine (2,000 to 3,000 rpm) two or three times under no-load, then run engine at idle speed for about J 1 minute.
Start engine and rev it (2,000 to 3,000 rpm) two or three times under no-load, then run engine at idle speed. Start engine and warm it up until engine coolant temperature indicator points to the middle of gauge. Check engine coolant temperature sensor and its circuit, and repair or replace if necessary.
Manual Cover
General