Manual Description
If a driver air bag direct-connect K harness connector is damaged, the spiral cable must be replaced. Disconnect the negative and positive battery terminals, then wait at least three minutes. If equipped, remove the steering wheel switch screws (A) and release the tabs (3) from the driver air bag module.
Then while pressing tabs (2), pull wiper and washer switch away from spiral cable to remove. Then while pressing tabs (2), pull lighting and turn signal switch toward driver door to remove. Remove the screws, then release the tab at the top and pull the spiral cable away from the steering column assembly.
Make sure spiral cable alignment and centering marks (B) are matched and in the neutral position. Place steering wheel in straight ahead position, then install it with the locating pin hole (C) directly over spiral cable locating pin. B Service replacement passenger air bag modules use tab-locking style harness connectors.
Manual Cover
General