Manual Description
If necessary, remove the support bearing bracket bolts and the support bearing bracket. Tighten the support bearing bracket plate bolts in 2 stages in the order of 1 to 2 as shown. Replace the joint sub-assembly if there are any non-standard conditions of components.
Using a piece of wood and a suitable tool, tap on the wheel hub M lock nut to disengage the drive shaft from the wheel hub and bearing. A When installing a the cotter pin (1) and the nut retainer (2), securely bend the cotter pin to prevent rattles. O Replace the joint sub-assembly if there are any non-standard conditions of components.
Screw a suitable tool (A) into the joint sub-assembly screw part to a length of 30 mm (1. Support the drive shaft with one hand and pull out the joint sub-assembly from the shaft. Apply the specified amount of grease to the inside of the large diameter side of the boot.
Manual Cover
General