Manual Description
When checking the headlamp on/off operation, check it on vehicle and with the power connected to the vehicle-side connector. Do not touch the headlamp bulb glass surface with bare hands or allow oil or grease to get on it. Do not touch the headlamp bulb just after the headlamp is turned off, because it is very hot.
Do not use organic solvent (paint thinner or gasoline) to clean lamps and to remove old sealant. When energized, these relays J direct power to the respective headlamps, which then illuminate. Under this condition, the headlamps remain illuminated for 5 minutes, unless the combination switch (lighting switch) position is changed.
If the combination switch (lighting switch) position is changed, then the headlamps are turned off. C Displays status of the lighting switch as judged from the lighting switch signal. Check continuity between inoperative front combination lamp L connector and ground.
Manual Cover
General