Manual Description
The axle oil seal must be replaced every time the axle shaft assembly is C removed from the axle shaft housing. Remove the parking brake assembly from the back plate. Remove the four axle shaft bearing cage nuts and lock washers.
Remove the axle shaft assembly using Tools as shown. The axle oil seal must be replaced every time the axle shaft assembly is removed from the axle shaft housing. Remove the snap ring from the axle shaft using suitable snap ring pliers.
Secure the axle shaft in a suitable vise, then use a 1/4 in size drill bit to drill a hole approximately 3/4 into the thickness of the K bearing ring retainer [3/4 thickness is approximately 6. Pull the axle shaft bearing off of the axle shaft using Tool and a suitable press. If installing a new axle shaft, install a new wheel sensor rotor onto the new axle shaft.
Manual Cover
General