Manual Description
The alignment specifications programmed into your alignment machine that operate these indicators may not be correct. After installing the alignment targets or head units, raise the vehicle and rotate the wheels 1/2 turn both ways. If it is out of the specification value, inspect and replace any damaged or worn rear suspension parts.
If it is out of the specification, inspect and replace any damaged or worn rear suspension parts. Put a mark on base line of the tread (rear side) of both tires at the same height of hub center. If wheels have rotated more than 180 degrees (1/2 turn), try the above procedure again from the beginning.
Remove shock absorber mask from trunk side finisher using a flat-bladed screwdriver. Remove upper nut of the shock absorber, and then remove washer (upper), bushing (upper) from shock absorber. When installing body side bushing (upper), install the projection to the body side hole securely.
Manual Cover
General