Manual Description
These conditions should be duplicated when verifying and isolating the cause of the H noise. Most of these incidents can be repaired by repositioning the component or applying urethane tape to the contact area. The best method is to secure, move or insulate one component at a time and test drive the vehicle.
Repairs can usually be made by moving, adjusting, securing, or O insulating the component causing the noise. Disengage instrument side finisher metal clips, and then remove M instrument side finisher. Lift the side ventilator up from the bottom, pull backward while disengaging the side ventilator assembly upper pawls, and then remove the side ventilator.
Disconnect in-vehicle sensor and harness connector, and then remove instrument lower finisher. Insert a suitable tool into the bottom gap of side ventilator assembly after removing the instrument side mask and push against B as shown to disengage the pawl. Remove screws, and then remove instrument panel & pad from passenger door opening portion.
Manual Cover
General