Manual Description
Set vehicle to the straight-ahead position and confirm steering wheel is in the neutral position. Place front wheels on turning radius gauges and rear wheels on stands, so that vehicle can be level. Check steering gear assembly, steering column assembly and front suspension components for wear or damage if any of the turning angles are different from the specified value.
This will omit neutral position alignment procedure during spiral cable installation. Replace steering column assembly (with motor, reduction gear, sensor) if (L) is outside the standard. Remove lower joint lower bolt and separate lower joint from steering gear assembly.
Lower the suitable jack to the position where the steering gear assembly can be removed. E Perform final tightening of nuts and bolts on each part under unladen conditions with tires on level ground when removing steering gear assembly. Make sure that the Tool reads the specified value when ball stud and inner socket start to move.
Manual Cover
General