DIAGNOSTIC PROCEDURE 3
=NGEL0059S03
SYMPTOM: Wiper and washer activate individually but not in
combination.
1 CHECK FRONT WASHER SWITCH INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect front wiper amplifier connector.
3. Check harness continuity between front wiper amplifier terminal 5 and ground.
AEL549C
Continuity:
Condition of front washer switch: OFF
No
Condition of front washer switch: ON
Yes
OK or NG
OK ᮣ Go to DIAGNOSTIC PROCEDURE 1.
NG ᮣ Check harness for open or short between front wiper amplifier terminal 5 and front wiper
switch terminal 18.
SEL543TA
Removal and Installation
NGEL0060
WIPER ARMS
NGEL0060S01
1. Prior to wiper arm installation, turn on wiper switch to operate
wiper motor and then turn it “OFF” (Auto Stop).
2. Lift the blade up and then set it down onto glass surface to set
the blade center to clearance “L
1
” & “L
2
” immediately before
tightening nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper motor
and then turn it “OFF”.
4. Ensure that wiper blades stop within clearance “L
1
” & “L
2
”.
Clearance “L
1
”: 25 mm (.98 in)
Clearance “L
2
”: 25 mm (.98 in)
¼ Tighten wiper arm nuts to specified torque.
Front wiper: 13 - 18 N·m (1.3 - 1.8 kg-m,9-13ft-lb)
FRONT WIPER AND WASHER
Trouble Diagnoses (With intermittent wipers) (Cont’d)
EL-118