Manual Description
Computing this information, ignition C signals are transmitted to the power transistor. The basic ignition timing is programmed within the anti-knocking zone, if recommended fuel is used under dry conditions. Fuel cut will operate until the engine speed reaches 1,500 rpm, then fuel cut is cancelled.
Start engine and warm it up until engine coolant temperature indicator points to the middle of gauge. Open engine hood and run engine at about 2,000 rpm for about E 2 minutes under no-load. Rev engine two or three times under no-load, then run engine at idle speed for about 1 minute.
Start engine and rev it (2,000 to 3,000 rpm) two or three times under no-load, then run engine at idle speed. Turn off engine and connect throttle position sensor harness connector to throttle position sensor. Rev engine (2,000 to 3,000 rpm) two or three times under no-load, then run engine at idle speed.
Manual Cover
General