Manual Description
Apply the sealant without breaks to the specified area with the specified dimensions. After 30 minutes or more have passed from the installation, fill the engine with the correct oil and coolant. Blow air again into all the radiator core surfaces once per minute until no water blows out and the core is I dry.
After installing water pump, connect hose and clamp securely, then check for leaks using radiator cap tester. To avoid deforming timing cover, make sure there is adequate clearance between it and the hose clamp. Use a scraper to remove old liquid gasket from water inlet and engine mating surfaces.
After repairing or replacing the radiator as necessary, installation is in the reverse order of removal. After installation, run the engine until it reaches operating temperature and check the system for leaks. C Install the drive belt only after the fan and fan coupling to water pump flange bolts/nuts have been properly torqued.
Manual Cover
General