Manual Description
Install brake hose by aligning with the protrusion on caliper assembly, and tighten union bolt to the specified torque. Install brake tube to brake hose, then tighten flare nut to the specified torque using a flare nut wrench. Install brake tube to brake hose, then tighten flare nut to the specified torque using a flare nut wrench or suitable tool.
While depressing brake pedal under a force of 785 N (80 kg, 177 lb) with engine running for approximately 5 seconds, check for fluid leaks from each part. Using a flare nut wrench or suitable tool, disconnect brake tube from master cylinder assembly. Apply brake fluid or rubber grease to new grommets, then insert into master cylinder sub-assembly.
Then with brake pedal fully depressed, start engine and when the vacuum pressure reaches the standard, make sure the clearance between brake pedal and floor panel decreases. Loosen lock nut to adjust input rod length so that the length "B" (in the figure) satisfies the specified value. After adjusting "B", temporarily tighten lock nut and install booster assembly to the vehicle.
Manual Cover
General