Manual Description
If the engine is already running, turn it off and allow 10 minutes before checking. After warming up engine, make sure there is no leakage of engine oil with running engine. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
Install a new washer on the oil drain plug, then install the oil drain plug in the oil pan. Warm up the engine and check the area around the drain plug and oil filter for any oil leaks. Apply clean engine oil to the oil filter seal circumference of the new oil filter as shown.
Screw on the oil filter manually until it touches the installation surface, then tighten it by 2/3 turn as shown. Disconnect water hoses from oil cooler, pinching hoses near oil cooler to prevent engine coolant from spilling. Check oil cooler for clogging by blowing compressed air through engine coolant inlet.
Manual Cover
General