Manual Description
Thereafter, the daytime lights will continue to operate when the parking brake is applied. The high beam lamps are wired in series which causes them to illuminate at a reduced intensity. Off-road lamp cover sensors Senses whether the off-road lamp covers are installed.
Under this condition, the headlamps remain illuminated for 5 minutes unless the combination switch (lighting and turn signal switch) position is changed. If the combination switch (lighting and turn signal switch) position is changed, then the headlamps are turned off. When the brake pedal is depressed, the combination meter receives a stop lamp switch signal from the stop lamp switch.
After a series of the following operations is repeated 3 times, auto active test is completed. Check the voltage between the off-road lamps switch connector M80 terminal 1 and ground. Check continuity between the off-road lamps switch harness connector M80 terminals 2, 6 and ground.
Manual Cover
General