Manual Description
Loosen lock nut (A) on the input rod, then turn input rod to adjust the brake pedal to specified height. This might damage the paint, so when splashing it, immediately wipe off the area and wash away with water. Make sure there is no foreign material in reservoir tank, and refill with new brake fluid.
Repeat the process a few times, then pause to add new brake fluid to master cylinder. With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately. There should be no binding or sticking when applying or releasing the brake pedal.
Remove union bolt and copper washers, then remove brake hose from caliper assembly. Install brake hose by aligning with the protrusion on caliper assembly, then install new copper washers and union bolt. Install brake tube to brake hose, then tighten flare nut to the specified torque using a suitable tool.
Manual Cover
General