Manual Description
The procedure for attaching and for removing the jumper cables is described below. Perform each of the following steps only in the order described, which follow the letters shown in the illustration ⇒ fig. Attach one end of the red jumper cable to the positive terminal (+) of the dead battery: (1) ⇒ .
Attach the other end of the red jumper cable to the positive terminal (+) of the good battery (booster battery): (2). Attach one end of the black jumper cable to the negative terminal (-) of the booster battery: (2). Attach the other end of the black jumper cable (3) to a bare metal part of the vehicle with the dead battery.
You may also attach the cable to the engine block itself or to the towing eye installed on the front of the vehicle Attach the clamp to a point that is as far away as possible from the dead battery (1) ⇒ . Route the jumper cables so that they cannot get caught in any moving parts in the engine compartment of either vehicle. Starting the engine Start the engine of the vehicle with the good battery that is providing help and let it run at idle speed.
Manual Cover
General