Manual Description
Sparks or exhaust particulate can plug to drain the water from the case. Remove the tailpipe by pulling it out of the the water may affect other engine parts. Turn the rear brake light switch adjusting nut while holding the brake light switch in place.
There is no need to check the electrolyte or to add distilled water. Install the front carrier by installing the bolts positive lead must be connected before and tightening them to the specified torques. Remove the burnt-out bulb by pushing it in and turning it counterclockwise.
Install the wheel with the arrow mark pointing by turning it clockwise. You could be burned by hot fluid and steam blown out under pressure. Allow any remaining pressure to escape before completely removing the cap.
Manual Cover
General