When refueling your motorcycle observe the following rules.
Refuel in a ventilated area with the engine turned off.
Remove fuel filler cap slowly.
Do not smoke or allow open flames or sparks when refueling or servicing the fuel system.
Do not fill fuel tank above the bottom of the filler neck insert.
Leave air space to allow for fuel expansion.
Do not store motorcycle with gasoline in tank within the home or garage where open flames,
pilot lights, sparks or electric motors are present. Gasoline is extremely flammable and highly
explosive, which could result in death or serious injury. (00003a)
Engine exhaust from this product contains chemicals known to the State of California to
cause cancer, and birth defects or other reproductive harm. (00004f)
Do not run motorcycle in a closed garage or confined area. Inhaling motorcycle exhaust,
which contains poisonous carbon monoxide gas, could result in death or serious injury.
(00005a)
A new motorcycle must be operated according to the special break in procedure. See Break in Riding Rules.
Operate motorcycle only at moderate speed and out of traffic until you become thoroughly familiar with its operation and handling characteristics
under all conditions.
NOTE:
Harley Davidson recommends that you obtain information and formal training in the correct motorcycle riding technique. In the United States, the Motorcycle
Safety Foundation
®
offers beginning, advanced and 3 wheel basic rider safety courses. Call 800 446 9227 for information.
Travel at speeds appropriate for road and conditions and never travel faster than posted
speed limit. Excessive speed can cause loss of vehicle control, which could result in death or
serious injury. (00008a)
Do not exceed the legal speed limit or drive too fast for existing conditions. Always reduce speed when poor driving conditions exist. High speed
increases the influence of any other condition affecting stability and increases the possibility of loss of control.
Steering and handling characteristics for a three wheeled motorcycle are different than a two wheeled motorcycle. Approach corners and sharp
turns using the appropriate speed and steering technique to handle the turn and prevent rollover.
Pay strict attention to road surfaces and wind conditions, and always keep both hands on the handlebar grips when riding the motorcycle. The
vehicle may be subject to upsetting forces such as wind blasts from passing trucks, holes in the pavement, rough road surfaces and rider control
error. These forces may influence the handling characteristics of your motorcycle. If you experience these conditions, reduce speed and guide the