result in electric shock and death or serious injury.
(00464b)
Do NOT pull on any electrical wires. Pulling on electrical
wires may damage the internal conductor causing high
resistance, which may result in minor or moderate injury.
(00168a)
Check the spark plugs at proper intervals. Refer to Regular Service Intervals: 2013 Touring
Models.
1. Disconnect spark plug cables from plugs by pulling up on the molded connector caps.
2. Check spark plug type. Only use those spark plugs specified for your model motorcycle.
3. Check spark plug gap against specifications table.
NOTE:
If a torque wrench is not available, tighten new spark plugs finger tight and then tighten an
additional one quarter turn with a spark plug wrench.
4. Always tighten to the proper torque. Spark plugs must be tightened to the torque specified
for proper heat transfer. Refer to Electrical.
5. Connect each molded connector cap until the cap snaps firmly into place over the spark
plug.
Ignition
The engine in your motorcycle has been designed specifically to achieve optimum fuel economy
within exhaust emission controls. Factory programmed ignition characteristics provide maximum
engine performance and driveability.
Air Cleaner
Do not use gasoline or solvents to clean filter element.
Flammable cleaning agents can cause an intake system
fire, which could result in death or serious injury. (00101a)
Compressed air can pierce the skin and flying debris from
compressed air could cause serious eye injury. Wear
safety glasses when working with compressed air. Never
use your hand to check for air leaks or to determine air
flow rates. (00061a)
Install air filter before running engine. Failure to do so can
draw debris into the engine and could result in engine
damage. (00207a)
1. Refer to Regular Service Intervals: 2013 Touring Models. Remove air cleaner cover
and inspect filter element at proper intervals. When operated under dusty conditions, inspect
more often.
