7. If motorcycle is to be covered, use a material such as light canvas that will breathe. Plastic
materials that do not breathe promote the formation of condensation. Do not bend or tuck
antennas under the cover. Either remove the antennas (if equipped) or allow them to
protrude through the cover.
Removing Motorcycle From Storage
The clutch failing to disengage can cause loss of control,
which could result in death or serious injury. Prior to
starting after extended periods of storage, place
transmission in gear and push vehicle back and forth
several times to assure proper clutch disengagement.
(00075a)
NOTE:
When lubricants have been contaminated by water, they often take on a milky white appearance.
Always drain contaminated lubricants and refill with the appropriate Harley Davidson lubricant
prior to motorcycle operation.
1. See Battery for proper battery care. Charge and install the battery.
2. Start the engine and run until it reaches normal operating temperature. Turn off engine.
3. Check engine oil level.
4. Check the transmission lubricant level.
5. Check controls to be sure they are operating properly. Operate the front and rear brakes,
throttle, clutch and shifter.
6. Check steering for smoothness by turning the handlebars through the full operating range.
Be sure tires are properly inflated, balanced, undamaged,
and have adequate tread. Inspect your tires regularly and
see a Harley Davidson dealer for replacements. Riding
with excessively worn, unbalanced, improperly inflated,
overloaded or damaged tires can lead to tire failure and
adversely affect stability and handling, which could result
in death or serious injury. (00014b)
7. Check tire pressure. Refer to Specified Tires for specified pressure.
8. Check overall tire condition. See Tires.
9. Check all electrical equipment and switches including the stop lamp, turn signals and horn
for proper operation.
10. Check for any fuel, oil or brake fluid leaks.
Turn engine over a few times to be sure there is no oil in
the crankcase and that all oil has been pumped back into
the oil tank. Stop engine and re check oil level. Failure to
do so can result in engine damage. (00071a)
