Strap Slots: FLHRC
Installation
1. See Seat Mounting Slot. Place seat on frame backbone.
2. To protect finish of Tour Pak, cover rear seat mounting bracket with palm of hand.
3. See Seat Tongue. While raising rear of seat approximately 3 in 76.2 mm , use other hand
to firmly push downward and rearward until tongue engages slot in seat.
4. Push seat forward. Align mounting bracket with seat retention nut on rear fender.
5. Install fastener to secure seat to rear fender. Tighten to 20 40 in lbs (2.3 4.5 Nm).
NOTE:
If the seat retention nut is damaged or lost, see service manual for instructions.
6. See Strap Slots: FLHRC. On FLHRC and FLTRU, carefully route free end of passenger
seat strap through slots in the seat.
7. See Seat Strap Bracket Screw (typical). Install end of seat strap in the bracket slot.
Install seat strap bracket fastener. Tighten to 48 72 in lbs (5.4 8.1 Nm).
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
8. Pull up on seat to verify that it is properly secured.
9. Install saddlebag.
10. If moved, install Tour Pak in its original location.
