damage. (00210b)
5. Install new bulb. Align the tab on the bulb with the notch in the headlamp housing.
6. See Wire Retaining Clip. Secure wire retaining clip (1) under lip of retainer (2).
NOTE:
If loosened to release wire retaining clip, hold retainer in place and tighten screw until snug.
Verify that reflector cone is still centered under decorative logo.
7. Install rubber boot.
8. HDI models: Rotate position lamp bulb retainer 1/4 turn counterclockwise to remove.
Replace bulb and install bulb retainer in lamp housing.
1. Wire retaining clip
2. Retainer
Wire Retaining Clip
Installation
1. Install headlamp connector.
2. Install headlamp assembly. Tighten to:
a. Non fairing equipped: 9 18 in lbs (1.0 2.0 Nm).
b. Fairing equipped: 22 32 in lbs (2.5 3.6 Nm).
3. Secure the headlamp door (chrome ring) with screw. Tighten to 9 18 in lbs (1.0 2.0 Nm).
Headlamp Bulb Replacement: Dual Headlamp Models
Removal
1. Carefully pry headlamp trim from front of motorcycle.
2. Remove four screws securing headlamp assembly to trim ring/adjuster assembly.
