momentarily push the RESUME/SET switch on the right handlebar to SET. After a delay of
about 1 1/2 seconds, the icon will turn green on the face of the gauge to indicate the
selected cruising speed is locked in.
Disengaging Cruise Control
The cruise control automatically disengages whenever the cruise control module receives one of
the following inputs:
1. Front and/or rear brake is applied.
2. Throttle is rolled back or closed, thereby actuating roll off (disengage) switch.
3. Motorcycle clutch is disengaged (module senses too great an increase in RPM).
4. Vehicle speed is out of the operating range.
NOTE:
Rolling on the throttle more than 10 mph 16 km/h above the set speed may also disengage cruise
control.
When the cruise is disengaged, the cruise icon on the face of the gauge is orange. The orange
cruise control system icon remains ON until the main switch is turned off.
However, should you decide to SET a cruise speed, RESUME last set speed, ACCELERATE or
DECELERATE, simply press the RESUME/SET switch in desired direction.
Resuming Cruise Speed
If the system is deactivated using one of the methods described under DEACTIVATING CRUISE
CONTROL, the system is still ON should you decide to RESUME the set speed. To accomplish
this, simply press the RESUME/SET switch to RESUME.
NOTE:
The computer will hold the SET speed in memory for the RESUME function. If the vehicle speed
drops more than 15 mph 24 km/h below the SET speed, speed can no longer be RESUMED. If
cruise operation is still desired, press the RESUME/SET switch to SET to reset the cruise speed.
Accelerating Cruise Speed
1. With the cruise speed set, momentarily press the RESUME/SET switch to RESUME to
increase the speed by 1 mph 1.6 km/h .
2. Pressing and holding the RESUME/SET switch at RESUME will cause the system to
continue to increase speed in increments of approximately 1 mph 1.6 km/h until the switch is
released. There is a delay of about 2 seconds before the speed increases.
Decelerating Cruise Control
1. With the cruise speed set, momentarily press the RESUME/SET switch to SET to reduce
the speed by 1 mph 1.6 kph .
2. Pressing and holding the RESUME/SET switch at SET will cause the system to continue to
reduce speed in increments of approximately 1 mph 1.6 kph until the switch is released.
There is a delay of about 2 seconds before the speed decreases.
Deactivating Cruise Control
