Removal
1. Open Tour Pak (if equipped) to move passenger backrest out of the way. See Tour Pak.
NOTE:
The Tour Pak must be positioned to the rear to gain access to the seat mounting bracket
screw. If the Tour Pak is in the forward position, remove Tour Pak and temporarily install in
rearward position.
2. Remove the left side saddlebag.
Detach passenger seat strap before removing seat. Failure
to do so can result in damage to rear fender paint. (00225a)
3. See Seat Strap Bracket Screw (typical). Remove fastener from seat strap bracket.
4. Pull upward on strap to free it from slot in bracket.
5. See Strap Slots: FLHRC. On FLHRC and FLTRU, carefully pull passenger seat strap
through slots in the seat to remove.
6. Place seat strap on right side of vehicle.
7. To protect finish of Tour Pak, cover rear seat mounting bracket with palm of hand.
8. See Seat Tongue. While pushing seat forward, raise rear of seat until bracket clears top of
Tour Pak (if equipped). Push seat rearward slightly to free tongue from slot in seat.
9. Remove seat from frame.
Seat Strap Bracket Screw (typical)
