Main Fuse
See Fuse Block Area. A 40 amp main fuse (2) is located near the fuse block. Removing the
main fuse will disconnect power to all systems except the starter motor/solenoid.
If equipped with security system siren, turn the ignition switch ON with the hands free fob present
to disarm the security system before removing the main fuse.
System Fuses
Do not skip any steps for fuse replacement. Skipping fuse
replacement steps can result in damage to the sound
system and/or other motorcycle systems. (00223a)
See Fuse Block Area. Fuses are located under left side cover.
If fuse replacement does not correct a problem, see a Harley Davidson dealer for electrical
diagnosis.
1. Place the ignition switch in the OFF position.
NOTE:
Removal of side cover requires no tools. Pull side cover to remove. To install, align barbed
studs on side cover with grommets in frame and push.
2. Remove left side cover.
3. Press latch on bottom of fuse block cover (1) and swing bottom of the cover out. Remove
the cover.
NOTES:
The fuse block cover has a fuse puller (3) attachment that may be used to remove
fuses.
The fuse block cover label for fuse 4, Radio/siren power refers to the emergency siren
installed on police models.
4. See Fuses. Remove fuse and inspect the element.
Always use replacement fuses that are of the correct type
and amperage rating. Use of incorrect fuses can result in
damage to electrical systems. (00222a)
5. Replace the fuse if the element is burned or damaged.
NOTE:
Use automotive type fuses for replacements. Two spare fuses can be found in the fuse
block.
6. Install the fuse block cover.
7. Install left side cover.
