Check Engine Lamp
See Instrument Lamps. The check engine lamp is located along the bottom of the speedometer
face. Its purpose is to indicate whether the engine/engine management system is operating
normally. The check engine lamp color is amber.
The check engine lamp normally comes on when the ignition is first turned on and remains on for
approximately 4 seconds, as the engine management system runs a series of self diagnostics.
If the check engine lamp comes on at any other time, see a Harley Davidson dealer.
Low Fuel Lamp
See Instrument Lamps. The low fuel lamp is located in the speedometer face, lower center by
check engine lamp. The low fuel lamp illuminates to indicate that you have approximately 1.0
gallon 3.8 liters of gasoline left in the tank. The low fuel lamp color is amber.
If the low fuel lamp remains lit after adding fuel or filling the fuel tank, see your Harley Davidson
dealer.
Battery Discharge Lamp
See Instrument Lamps. The red battery charging lamp indicates either overcharging or
undercharging of the battery. Refer to Battery.
Cruise Control Equipped Models
Cruise control equipped models feature two additional indicator lamps.
See Instrument Lamps. A green or orange lamp on the tachometer or speedometer face
indicates the cruise control is SET (green) or NOT SET (orange).
See Cruise Control Fairing Cap Switch. An orange lamp on the cruise control switch
which indicates the cruise control is ON or OFF.
Sixth Gear Lamp
See Instrument Lamps. The sixth gear lamp on the speedometer face indicates when the
transmission is in sixth gear.
Security System Lamp
See Instrument Lamps. The red security system lamp on the speedometer face indicates when
the security system is armed. Refer to Harley Davidson Smart Security System.
ABS Lamp
See Instrument Lamps. On ABS equipped models, the amber ABS indicator lamp begins to
flash at key ON to indicate that the system is operational. It continues to flash until motorcycle
speed exceeds 3 mph 5 km/h . Continuous illumination of the lamp will only occur when ABS
detects that the system is malfunctioning. In the diagnostic mode, the lamp will also illuminate to
indicate the presence of diagnostic trouble codes (DTCs). See a Harley Davidson dealer for
service.
If ABS lamp remains on continuously, the ABS is not
